1-877-463-8256

CONTACT

RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 1-1/2" flashing section for commonly used trim 
  • Closures:  12-36 LT, 12-36 ST, LP Vented 12-36 LT
  • Misc:  See accessory section for more roofing accessories

24 Gauge Colour Chart

Recommended Fastener Pattern at Eaves, Ridges & End laps

INSTALLATION HELP

26 Gauge Colour Chart

1-1/2" Flashing Guide

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

The 12-36 panel is relatively easy to install.  Simply lay your first sheet on the

opposite end of your building of the prevailing winds and follow the recommended

fastener pattern to the right.  The second sheet can be laid with one rib overlapping

the first panel, as per the picture to the right, and follow that pattern for each

corresponding panel.  For more in depth installation advice on panels, flashing and

accessories, download/print our installation guide below.

12-36 Spec Page

SPECIFICATIONS

  • Use:  Roof/Wall
  • Gauges:  26, 24
  • Slope:  1/12 and greater
  • Coverage:  36" width
  • Length:  3' to 50'
  • Rib Height:  1-1/2" on 12" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Open Spacing or Solid Substrate

Exposed Fastener Panel Installation Guide


12-36 Load Table

Overlap Side

Stock COLOUR OPTIONS

​​​ 12-36 Panel 

SEE MORE PICTURES IN THE PROJECT GALLERY

29 Gauge Colour Chart

RESOURCES

2806-5th Street

Nisku, AB, CAN

T9E 0H1

Recommended Fastener Pattern

COMMON APPLICATIONS

Exposed Fastener Install Guide

Our 12-36 profile is the panel of choice for industrial and light commercial metal roofing and siding applications, and is an excellent choice for pre-engineered metal buildings.  The 12-36 profile provides the strength and durability to withstand the toughest conditions and is ideal for slopes as low as 1/12.



Copyright 2019

Recommended Fastener Patterns

* Orange available in 29 gauge only

HEAD OFFICE

* Colours are a guideline only and may appear different on different screens, contact your nearest branch for more accurate colour samples.

Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.