Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.

Overlap Side

SPECIFICATIONS

  • Use:  Wall/Liner
  • Gauges:  26, 24
  • Coverage:  36" width
  • Length:  3' to 50'
  • Rib Height:  1-1/2" reverse rib on 12" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Open Spacing or Solid Substrate

SEE MORE PICTURES IN THE PROJECT GALLERY

24 Gauge Colour Chart

The 12-36 reverse panel is relatively easy to install.  Simply lay your first sheet on the opposite end of your building of the prevailing winds and follow the recommended fastener pattern to the right.  The second sheet can be laid with one rib overlapping

the first panel, as per the picture to the right, and follow that pattern for each corresponding panel.  For more in depth installation advice on panels, flashing and accessories, download/print our installation guide below.

Exposed Fastener Panel Installation Guide

* Available in 26 and 24 gauge.

*** Colours are representative only, please visit your nearest branch for physical colours samples.

26 Gauge Colour Chart

HEAD OFFICE

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

Stock COLOUR OPTIONS

12-36 Rev Load Table

The 12-36 Reverse Profile is an excellent choice for exterior walls on pre engineered, insulated metal buildings.  The unique profile allows the panel to compress any pre eng drape insulation while causing minimal distortion to the panel itself. 



RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 1-1/2" flashing section for commonly used trim 
  • Closures:  12-36 LT, 12-36 ST, LP Vented 12-36 LT
  • Misc:  See accessory section for more roofing accessories

CONTACT

INSTALLATION HELP

Recommended Fastener Patterns

1-1/2" Flashing Guide

Exposed Fastener Install Guide

Recommended Fastener Pattern at Eaves, Ridges & Endlaps

RESOURCES

1-877-463-8256

2806-5th Street

Nisku, AB, CAN

T9E 0H1

​​​ 12-36 Reverse Panel 

Copyright 2019

Recommended Fastener Pattern

12-36 Rev Spec Page

COMMON APPLICATIONS