Recommended Fastener Patterns

Exposed Fastener Panel Installation Guide

The 7/8" corrugated panel is relatively easy to install.  Simply lay your first sheet on the

opposite end of your building of the prevailing winds and follow the recommended

fastener pattern to the right.  The second sheet can be laid with one rib overlapping

the first panel, as per the picture to the right, and follow that pattern for each

corresponding panel.  For more in depth installation advice on panels, flashing and

accessories, download/print our installation guide below.

Stock COLOUR OPTIONS

Exposed Fastener Install Guide

26 Gauge Colour Chart

CONTACT

SPECIFICATIONS

  • Use:  Wall/Liner
  • Gauges:  26, 24
  • Coverage:  35" width (26ga), 36" width (24ga)
  • Length:  3' to 50'
  • Rib Height:  7/8" on 2.66" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Open Spacing or Solid Substrate

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

Overlap Side

HEAD OFFICE

Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.


* Orange available in 29 gauge only

* Colours are a guideline only and may appear different on different screens, contact your nearest branch for more accurate colour samples.

INSTALLATION HELP

7/8" Corrugated Spec Page

RESOURCES

7/8" Corrugated Load Table

​​​ 7/8" Corrugated Panel 

1-877-463-8256

RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 7/8" flashing section for commonly used trim 
  • Closures:  Corrugated LT, Corrugated ST
  • Misc:  See accessory section for more roofing accessories

2806-5th Street

Nisku, AB, CAN

T9E 0H1

Copyright 2019

COMMON APPLICATIONS

Recommended Fastener Pattern at Eaves, Ridges & Endlaps

SEE MORE PICTURES IN THE PROJECT GALLERY

24 Gauge Colour Chart

The 7/8" Corrugated Profile is one the longest standing metal profiles around.  It's wave like corrugation makes it the ideal profile for a wide array of projects, whether it be agricultural, commercial or residential.  The corrugated ribs at 2.66" on centre and 7/8" high give this profile a strong appearance on any application.  



29 Gauge Colour Chart

Recommended Fastener Pattern

7/8" Flashing Guide