​​​ 9-36 Panel 

INSTALLATION HELP

Exposed Fastener Panel Installation Guide

9-36 Spec Page

SPECIFICATIONS

  • Use:  Roof/Wall/Liner
  • Gauges:  29, 26, 24
  • Slope:  3/12 and greater
  • Coverage:  36" width
  • Length:  3' to 45'
  • Rib Height: 3/4" on 9" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Open Spacing or Solid Substrate

2806-5th Street

Nisku, AB, CAN

T9E 0H1

RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 3/4" flashing section for commonly used trim 
  • Closures:  9-36 LT, 9-36 ST, LP Vented 9-36 LT
  • Misc:  See accessory section for more roofing accessories

RESOURCES

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

3/4" Flashing Guide

* Colours are a guideline only and may appear different on different screens, contact your nearest branch for more accurate colour samples.

Recommended Fastener Patterns

The 9-36 Profile is the most versatile and economical panel we produce, making it a popular choice for both roofing and siding applications.  It's strength and durability make it an excellent choice for shops, barns, storage buildings and even residential applications.       



Recommended Fastener Pattern at Eaves, Ridges & Endlaps

1-877-463-8256

Overlap Side

HEAD OFFICE

Exposed Fastener Install Guide

COMMON APPLICATIONS

SEE MORE PICTURES IN THE PROJECT GALLERY

* Orange available in 29 gauge only

24 Gauge Colour Chart

29 Gauge Colour Chart

26 Gauge Colour Chart

9-36 Load Table


CONTACT

Stock COLOUR OPTIONS

Copyright 2019

The 9-36 panel is relatively easy to install.  Simply lay your first sheet on the

opposite end of your building of the prevailing winds and follow the recommended

fastener pattern to the right.  The second sheet can be laid with one rib overlapping

the first panel, as per the picture to the right, and follow that pattern for each

corresponding panel.  For more in depth installations advice on panels, flashing and

accessories, download/print our installation guide below.

Recommended Sheet Install Pattern

Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.

Recommended Fastener Pattern