Diamond Rib Spec Page

The Diamond Rib Profile is a strong, yet economical panel that can be used for agricultural, industrial and light commercial roofing and siding applications.  With ribs spaced at 6" on centre and 3/4" high, this profile offers an exciting aesthetic appearance while maintaining the strength and durability you need.



Recommended Fastener Pattern

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

3/4"" Flashing Guide

29 Gauge Colour Chart

SPECIFICATIONS

  • Use:  Roof/Wall
  • Gauges:  26, 24
  • Slope:  3/12 and greater
  • Coverage:  36" width
  • Length:  3' to 50'
  • Rib Height:  3/4" ribs on 6" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Open Spacing or Solid Substrate

24 Gauge Colour Chart

Exposed Fastener Install Guide

The Diamond Rib panel is relatively easy to install.  Simply lay your first sheet on the

opposite end of your building of the prevailing winds and follow the recommended

fastener pattern to the right.  The second sheet can be laid with one rib overlapping

the first panel, as per the picture to the right, and follow that pattern for each

corresponding panel.  For more in depth installations advice on panels, flashing and

accessories, download/print our installation guide below.

CONTACT

SEE MORE PICTURES IN THE PROJECT GALLERY

RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 3/4" flashing section for commonly used trim 
  • Closures:  Diamond LT, Diamond ST
  • Misc:  See accessory section for more roofing accessories

1-877-463-8256

Recommended Fastener Pattern at Eaves, Ridges & Endlaps

26 Gauge Colour Chart

2806-5th Street

Nisku, AB, CAN

T9E 0H1

RESOURCES

INSTALLATION HELP

24 Gauge Only Chart

Exposed Fastener Panel Installation Guide

Copyright 2019

​​​ Diamond Rib 

COMMON APPLICATIONS

* Colours are a guideline only and may appear different on different screens, contact your nearest branch for more accurate colour samples.

Overlap Side

* Orange available in 29 gauge only

Recommended Fastener Patterns

Diamond Rib Load Table

Stock COLOUR OPTIONS

Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.

HEAD OFFICE