1-877-463-8256

Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.

Copyright 2019

* Available in 26 and 24 gauge.

*** Colours are representative only, please visit your nearest branch for physical colours samples.

Recommended Fastener Pattern

Recommended Fastener Pattern at Eaves, Ridges & Endlaps

CONTACT

COMMON APPLICATIONS

2806-5th Street

Nisku, AB, CAN

T9E 0H1

Overlap Side

SEE MORE PICTURES IN THE PROJECT GALLERY

HEAD OFFICE

The Diamond Rib Reverse panel is relatively easy to install.  Simply lay your first sheet on the opposite end of your building of the prevailing winds and follow the recommended fastener pattern to the right.  The second sheet can be laid with one rib overlapping the first panel, as per the picture to the right, and follow that pattern for each corresponding panel.  For more in depth installation advice on panels, flashing and accessories, download/print our installation guide below.

Stock COLOUR OPTIONS

Exposed Fastener Install Guide

SPECIFICATIONS

  • Use:  Wall
  • Gauges:  26, 24
  • Coverage:  36" width
  • Length:  3' to 50'
  • Rib Height:  3/4" reverse ribs on 6" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Open Spacing or Solid Substrate

Diamond Rib Rev Spec Page


The Diamond Rib Reverse Profile further increases our line of metal roofing and siding panels.  The Diamond Rib Reverse profile works great on agricultural and light commercial buildings.   



INSTALLATION HELP

26 Gauge Colour Chart

Exposed Fastener Panel Installation Guide

​​​ Diamond Rib Reverse 

Diamond Rib Rev Load Table

Recommended Fastener Patterns

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

24 Gauge Colour Chart

RESOURCES

3/4" Flashing Guide

RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 3/4" flashing section for commonly used trim 
  • Closures:  Diamond LT, Diamond ST
  • Misc:  See accessory section for more roofing accessories