RESOURCES

Side Lap fasteners recommended when installing as roof panel


Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this

can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance

around the drill holes.

Overlap Side

The Low Rib panel is relatively easy to install.  Simply lay your first sheet on the

opposite end of your building of the prevailing winds and follow the recommended

fastener pattern to the right.  The second sheet can be laid with one rib overlapping

the first panel, as per the picture to the right, and follow that pattern for each

corresponding panel.  For more in depth installation advice on panels, flashing and

accessories, download/print our installation guide below.

Low Rib Spec Page

Recommended Fastener Pattern

Stock COLOUR OPTIONS

* Orange available in 29 gauge only

Recommended Sheet Install Pattern

29 Gauge Colour Chart

Low Rib Load Table

CONTACT

Copyright 2019


HEAD OFFICE

RECOMMENDED ACCESSORIES

  • Fasteners:  See fastener section for sizes and uses
  • Flashing:  See 3/8" flashing section for commonly used trim 
  • Closures:  Low Rib LT, Low Rib ST
  • Misc:  See accessory section for more roofing accessories

* Colours are a guideline only and may appear different on different screens, contact your nearest branch for more accurate colour samples.

​​​Low Rib Panel 

Exposed Fastener Panel Installation Guide

TF: 1-877-463-8256

FAX: 1-780-955-8636

EMAIL: orderdesk@versaframe.ca

COMMON APPLICATIONS

Recommended Fastener Pattern at Eaves, Ridges & Endlaps

24 Gauge Colour Chart

26 Gauge Colour Chart

2806-5th Street

Nisku, AB, CAN

T9E 0H1

SEE MORE PICTURES IN THE PROJECT GALLERY

INSTALLATION HELP

Exposed Fastener Install Guide

SPECIFICATIONS

  • Use:  Curved Roof/Wall/Liner
  • Gauges:  29, 26
  • Coverage:  36" width
  • Length:  3' to 45'
  • Rib Height:  3/8" on 9" centres
  • Fastener System:  Exposed Fastener
  • ​Recommended Substrate:  Solid Substrate

Recommended Fastener Patterns

3/8" Flashing Guide

The Low Rib Profile offers plenty of flexibility for your roofing and siding needs. With a 3/8" low profile rib, this profile is capable of shaping itself over the curvatures on your building.  Low Rib is an excellent choice for quonset buildings, barns and other curved roofing and siding applications.



1-877-463-8256